xioa esp32s3 sense camera mount for MK4/S and MK3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
a small mount for an esp32s3 sense board I had, with a mount for a buck converter
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 85
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
this is a model for holding a small xiao esp32s3 sense board
parts used:
1x 30x30x10 5v fan
1x 10 ohm resistor (make the fan quieter)
3x M3X6 screws
2x M3x16 screws
4x M3 hex nuts
1x usb-c breakout board (for power)
1x LM2596 buck converter
1x xiao esp32s3 sense board
1x 10x15mm heatsink (any size works, just needs to be big enough to effectively cool the camera board)
2x m3 power terminals
50 cm of wire (roughly, not exactly sure how much i used)
all in all, a neat little camera that sits nicely out of the way
mounted it on to the x motor with one screw.
the esp board slots into the "cam + antena holder", the antena attaches above it, on the flat piece.
this then slides into the other half.
the buck converter M3X6 screws into the “buck converter + cam mount” piece off on the right of the motor(two hex nuts should be inserted into the backside of it)
the fan is mounted in between the two pieces, attached with two screws.
to power it, and I am not responsible if you decide to replicate this, is attached to the main power supply of the printer in the buddy box using some m3 terminal connectors and fed through the X cable sleeve.
firmware uploading and connecting instructions:
https://github.com/prusa3d/Prusa-Firmware-ESP32-Cam
this is a modification and extension based of of the camera holder made by @ScottyDoesKno_259504