1 / 3
Insteon Mini Remote Holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Share Alike
I needed a new holder for one of my Insteon mini remotes as the little nodules wore flat after years of use, and I was too cheap to simply buy one if they are even available these days. This came in at only 9.2g of filament and just a few minutes of modelling so it was a no-brainer to simply knock one out.
I printed mine in Elegoo matte white PLA, as I had it to hand, and I stood it on its short end to print as shown in one of the photos. No supports are needed and no special treatment is required.