1 / 3
Dyson-ish fluffy cleaner tube and clip replacement — zdjęcie 1
1 / 3

Dyson-ish fluffy cleaner tube and clip replacement

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

replacement parts for the V8 Dyson fluffy cleaner

Ocena
0 / 5
Polubienia
4
Pobrania
41
Wydruki
1
Wyświetlenia
269
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Our beloved Dyson vacuum cleaner developed an issue with the fluffy cleaner attachment (Soft Brush) —the blue tube kept falling apart, making it pretty much useless.

I remembered I had some TPU filament lying around and figured it was worth a shot.

My first attempts at modeling and printing didn’t go so well, but after a few iterations, I finally ended up with a working prototype.

The original part is extremely flexible, so to replicate that with a homemade TPU version, I had to design the replacement tube slightly taller than the original to gain some extra flex.

Printing required supports and thin walls. I went with no infill and just a single perimeter.
Use standard TPU (TPU for AMS might be to stiff)

So far, it’s working! I can’t say much about long-term durability just yet, but fingers crossed!

 

I wasn’t patient or skilled enough to disassemble the attachment without causing some damage. The two red pins that fix and guide the lateral movement didn’t survive my repair attempt—so I tried to replace them with some spare parts as well.

 

Tagi