1 / 3
Schraubklemme für Sonnenschirm - Screw clamp for parasol — zdjęcie 1
1 / 3

Schraubklemme für Sonnenschirm - Screw clamp for parasol

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Ersatz für die Rohr-Schraubklemme (30mm / 31mm) Replacement for a screw clamp (30mm / 31mm)

Ocena
0 / 5
Polubienia
1
Pobrania
37
Wydruki
0
Wyświetlenia
141
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Mit diesen Ersatzteilen kann der Sonnenschirm wieder verwendet werden. Das Hauptrohr hat einen Durchmesser von 30mm. Das Tauchrohr hat 27mm Durchmesser.

neu -> zusätzlich 31mm / 26mm

Das Klemmstück wird am besten in TPU 72D gedruckt, weil es eine bessere Reibung erzeugt und daher der Griff nicht mehr so fest angezogen werden muss :-) 

Es wird in die Hülse vom Griff gedrückt und ist dann drehbar gelagert

Die Hülse und der Griff sollten in PA CF, PETG CF/GF oder ein ähnliches Filament gedruckt werden. Durch die Sonneneistrahlung sind andere Werkstoffe nicht ausreichend robust gegen Wärme, Verformung oder UV-Strahlung.

Ich empfehle mit Düse 0,6 und min. drei Perimeter.

Falls die Hülse auf dem Hauptrohr nicht ausreichend klemmen sollte, hilft eine kleine Menge Silikon gegen Verdrehen. Dann lässt sich die Hülse bei einem Defekt wieder entfernen.

The parasol can be used again with these spare parts. The main tube has a diameter of 30mm. The immersion tube has a diameter of 27mm.

new -> Vadditional 31mm / 26mm

The clamping piece is best printed in TPU 72D because it creates better friction and therefore the handle no longer needs to be tightened so tightly :-)

It is pressed into the sleeve of the handle and can then be rotated

The sleeve and the handle should be printed in PA CF, PETG CF/GF or a similar filament. Due to solar radiation, other materials are not sufficiently robust against heat, deformation or UV radiation.

I recommend using a 0.6 nozzle and at least three perimeters.

If the sleeve does not clamp sufficiently on the main tube, a small amount of silicone will help to prevent twisting. The sleeve can then be removed again in the event of a defect.

Translated with DeepL.com (free version)

Tagi