Schraubklemme für Sonnenschirm - Screw clamp for parasol
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ersatz für die Rohr-Schraubklemme (30mm / 31mm) Replacement for a screw clamp (30mm / 31mm)
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 38
- Makes
- 0
- Views
- 142
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
Mit diesen Ersatzteilen kann der Sonnenschirm wieder verwendet werden. Das Hauptrohr hat einen Durchmesser von 30mm. Das Tauchrohr hat 27mm Durchmesser.
neu -> zusätzlich 31mm / 26mm
Das Klemmstück wird am besten in TPU 72D gedruckt, weil es eine bessere Reibung erzeugt und daher der Griff nicht mehr so fest angezogen werden muss :-)
Es wird in die Hülse vom Griff gedrückt und ist dann drehbar gelagert
Die Hülse und der Griff sollten in PA CF, PETG CF/GF oder ein ähnliches Filament gedruckt werden. Durch die Sonneneistrahlung sind andere Werkstoffe nicht ausreichend robust gegen Wärme, Verformung oder UV-Strahlung.
Ich empfehle mit Düse 0,6 und min. drei Perimeter.
Falls die Hülse auf dem Hauptrohr nicht ausreichend klemmen sollte, hilft eine kleine Menge Silikon gegen Verdrehen. Dann lässt sich die Hülse bei einem Defekt wieder entfernen.
The parasol can be used again with these spare parts. The main tube has a diameter of 30mm. The immersion tube has a diameter of 27mm.
new -> Vadditional 31mm / 26mm
The clamping piece is best printed in TPU 72D because it creates better friction and therefore the handle no longer needs to be tightened so tightly :-)
It is pressed into the sleeve of the handle and can then be rotated
The sleeve and the handle should be printed in PA CF, PETG CF/GF or a similar filament. Due to solar radiation, other materials are not sufficiently robust against heat, deformation or UV radiation.
I recommend using a 0.6 nozzle and at least three perimeters.
If the sleeve does not clamp sufficiently on the main tube, a small amount of silicone will help to prevent twisting. The sleeve can then be removed again in the event of a defect.
Translated with DeepL.com (free version)