Mono m5(s) Build Plate v1 Drip Hanger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Leave in place build plate drip hanger for v1 plate, 2° rotation for better corner dripping. Requires 2 M3x16 & nuts.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 111
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a bracket that attaches to the part of the build plate where the knob holds it. The bracket is “permanently” attached to it so you don't have to fiddle with parts while holding the build plate in one hand trying to keep everything from dripping. (it is removable if needed).
All you have to do is pull the plate off, tilt it 45 degrees, and slide it back on.
Features:
- Leave in place solution
- Doesn't dip below the top of the resin vat
- 2 degree rotation for better corner drips
- Recessed screw holes
Requires two M3x16 hex socket screws and two m3 nuts.
There's literally only one way to assemble it because I designed it to match the shape of the print bed mounting point exactly. (Maybe a little too snug, it'll be real tight). Hand tighten the screws.
The one in the photos is FDM printed in Markforged Onyx with a 0.125 layer height, 20% infill.
I'm including my Fusion 360 file because I hope you'll make it your own.