Ladder rung pads
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Pads for the loft ladder of the roost 43 5th wheel
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 88
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The square ladder rungs of the roost 43 front loft ladder were pretty painful on your feet so I made these rung extensions i guess you could call them, they make the rung wider and act as a housing to add a 5mm tpu pad on top.
i printed these on an x1c but they are too long so you need to cut them in half in the slicer and add connectors i used x2 dowels, the tpu pads i cut in half as well but off set the joint of the pad and the rung and the pads dont need connectors obviously. They are attached with x4 ¾ self tapping screws.
- top rung extension and pad have been added
Material and print settings:
I printed the rungs in Petg-cf at 4 walls and about 50% cubic infill.
I printed the tpu pads at 4 walls and 10% gyroid infill
Print orientation:
I printed them with the finished end (not cut side) down on the plate and enabled auto tree support for the holes. Tpu pads i just printed textured side up..