Moto suspension forks boots-socks shields cover clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Motorcycle boots don't allow the stock shields to be fitted, and the rubber over aluminum seems like a too basic setup.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 272
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
Motorcycle boots don't allow thestock shields to be fitted, and the rubber over aluminum seems like a too basic setup. This can be used not only with boots but also for normal fork bushings protection, especially the tall one, in case the bike dont have this. There are two versions a ‘’slim'' one that is minimal and a taller one that also has some side deflectors. The diameter that would fit starts with D=63mm, but i can be bigger, no smaller than -10mm. An additional 2x M3x20 is needed. Fit it by inserting it where the fork tube section is minimal.
Fillament- must be at list a quality PETG, it will be flexible enough for fitting. Walls-3 or 4,, Infill-80% cubic.