Adafruit BH1750 Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bottom half of a case to fit an Adafruit BH1750 Light Sensor
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 86
- Wydruki
- 1
- Wyświetlenia
- 1967
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The include .3mf file fits an Adafruit BH1750 (light sensor board) snugly and has holes for the pin wires. This design doesn't have the STEMMA QT/Qwiic connection accessible, as my current project cannot use it, but allows for soldering to the main pins and through hole for the wires. While the case is specific to the BH1750, it can fit any other Adafruit sensor board with overall dimensions of 1"x.7". An acrylic/plexiglass cover can be cut and glued to the top of this case to seal it from the elements and allow light transmission. I hot glued the sensor to the case so it wouldn't slide around.
Print Settings
PLA
- .3 layer height
- 2 perimeters
- 4 top layers
- 3 bottom layers
- Total print time=10minutes.