Sectional Sofa Foot Connector – 3D Printable joiner for Couch Sections

Lock your sofa sections together with no tools, no damage, and no slipping apart. This connector holds the couch sections together using the existing screw on the feet to secure it in place. You don't need to screw anything into the frame. All you need to do is loosen (2) adjacent feet with (1) on each section, slide this connector between the feet and couch frame, and screw the feet back in tightly! 

Features:

• Should fit a wide range of sectional sofas as long as they have screw on feet.
• Prevents sections from sliding apart during use. (Or toddlers wedging themselves between sections to push them apart for fun)
• strong, tool-free, and easy to install or remove (if you can't get your whole hand around the foot to tighten it well then I recommend wedging some big things under both sections to allow you to tighten them down hard)
• Printable on FDM printers  with bed sizes around 240x240 (PETG, or ABS is recommended as you want a little flex when moving the couches around)

Compatibility:

• Should fit couch feet with screws smaller than 13mm. Screws of the feet can be between 60mm (measured nearest to nearest) and 190mm apart (measured farthest to farthest)
• The connector is 80mm wide, 260mm long, and 3mm thick (thickness can be easily adjusted in slicer)

Print settings:

• Layer height: 0.2mm
• Infill: 40-60%
• Supports: No
• Material: PETG, or ABS (haven't used PLA but not likely to work since it is likely to bend when moving the furniture)