Modular Little Tikes Story Dream Bookshelf
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A modular system for growing and expanding of Little Tikes Story Dream collections and characters.
- Ocena
- 4,667 / 5
- Polubienia
- 33
- Pobrania
- 216
- Wydruki
- 4
- Wyświetlenia
- 1324
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My kids have loved their story machine for years now and it has become a cornerstone of their bedtime routine. However, organizing these story collections has been a nightmare as we add more and more. Sure, there as commercial cases and some existing designs to store these but they all have one common issue: there's a limit to how much one can store.
Introducing the LTDS Bookshelf - Modular Version
Remixed from Eric's original design, the base model was revised to fit on a standard 220mm x 220mm build plate: no large formats required.
Several sections have been pre-designed to utilize new sections as your collection grows. The intended growth path is as follows:
“Upper” sections have no top magnets for a cleaner look. Start with a Left/Right of these
“Upper Mid” section has left/right/bottom magnets, best to slot between your Upper Left/Right sections
“Mid-Lower” sections feature top magnet holes, for when you need more height
“Vert” options are for straight towers; make a super skinny and tall bookshelf or get creative and make some bump-out sections
If you have outrageously tall characters such as any of the Trolls stories, print a section with extra top magnets and then make the “Tall Character Hat”.
Calibration and Fit
Highly recommended to run the "5x3 magnet test cube" to make sure your printer can handle the press fit tolerances. In some case you may find cleaning the edge holes with a sharp knife/deburring tool may improve results.
Purchased Components
Magnets: 5mm x 3mm Magnets (Amazon)
Super glue (optional, but recommended if your hole fit is loose)
Setting Recommendations
Use a 0.4mm nozzle with 0.45mm width
Use 3 walls/perimeters
No supports (lay on it's back)
Lower infill % is acceptable