Obsbot Meet SE Core One Mount - 10mmx3mm or 6mmx3mm Magnets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount Obsbot Meet SE for the Core One
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 536
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
In case this seems familiar to you, that's because I recently had posted a model for this same exact mount. I deleted that model though because upon building my Core One, I found that cable connector was too long for the mount and I didn't want to waste anyone's time.
I have fixed the mount such that it accommodates a 90-degree USB-C adaptor, found here: https://www.amazon.com/dp/B0C2WKDYT6
I also made sure the magnet holes only have ~0.05mm tolerance--the magnets will no longer slip out of the mount after attaching to the Core One frame.
To mount, you just need a 1/4-20 x 3/8 Inch countersunk bolt, for example: https://www.amazon.com/dp/B0DRFP5XTN. In metric units, that would be 6.35mm wide, 9.525mm long--just larger than an M6x9 countersunk bolt.
I printed these out using Hatchbox PETG with the following settings:
- Generic PETG base
- 230C for First & Other layers
- 0.2mm Structural Profile
- 2mm brim (not sure why prints tend to detach from the textured plate for me)
- 25% infill, Gryroid (you can likely get away with 15%)
- Prusa CORE One HF0.4 nozzle
- No supports needed :)
You can route the cable the same way as the door sensor is routed, or if you prefer the camera on the otherwise, you can route it alongside the filament sensor cabling.
To do so, you will need to take off the side panels (acrylic panels work too but it's less room to work with). You will find a cable zip tied along the frame just under the plate that the belt tensioner/motor mounts are attached to.
There are holes toward the back with grommets where the motor and sensor wires go. That's where I have the USB cable routed before connecting to my Pi 5.
Here is a sample pic of what the view looks like when mounted behind the front left pillar:

If anyone has any suggestions on what I can improve, let me know!
