Edge / corner protection, different sizes - to protect from injury and the edge/corner from damaging.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple two-part edge/corner protection to protect against injuries and/or to protect the edge/corner from damage.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 155
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- GNU General Public License v3.0
This is a simple two-part edge/corner protection to protect against injuries, damage to property and to protect the edge/corner from damage.
Sizes
Different sizes available. It's possible to adjust the FreeCAD model to your needs.
Printing
Print two parts for one edge/corner.
PETG recommended, Nozzle 0.4 mm, Layer height 0.2 mm (or variable layer height).
2 Wall loops, 3 bottom and top layers, infill 10 %. If bed adhesion is good, no brim is needed, even on bigger sizes (bigger ratio height/bottom area sticking on the bed).
Usage
Press the two parts together. If the gap is too large after pressing them together, you can use a hammer to gently tap the parts together.
If the protection on the edge is too loose, you can either use double-sided adhesive tape or a small amount of glue (no super glue recommended).
-------------------------------
The only reward for a hobbyist is likes.
Support / Donation for my work