True fruits watering can

Would you like to support my work? :)
Check out my  full catalog with exclusives, early access and commercial licences.
— 

A watering can attachment for a True Fruits bottle.

The top can be filled up without having to unscrew it. I had problems with watering cans that are too big for the sink and this one can be kept horizontal and therefore is easier to fill.

Size: 60 x 60 x 120 mm

This is the V2

Print settings

Required build volume: 60 x 60 x 120 mm

Material usage: 45g

Print time: 4h-5h

Material: PLA

Print direction: stls are rotated correctly, check images

Support: none

Nozzle size: 0,4 mm

Line width: 0,4 mm

Layer height 0,2 mm – 0,28mm

Outer walls: 3

Infill: 20%

Build plate adhesion type: a brim if you have bad bed adhesion

Watertight printing - If you have a well set up machine it comes automatically - Otherwise here are some tips: Increase your wall count (at least 3), level your bed nicely, decrease print speed, increase layer height (at least 0.2mm), check your seam quality, calibrate your e-steps and fine tune your retraction settings to make sure no holes appear after a layer change.