1 / 2
Bobbin Holder - L Size - Commercial Embroidery - Melco — zdjęcie 1
1 / 2

Bobbin Holder - L Size - Commercial Embroidery - Melco

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a bobbin holder for L Size commercial embroidery bobbins.

Ocena
0 / 5
Polubienia
5
Pobrania
56
Wydruki
0
Wyświetlenia
168
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Public Domain

This is a bobbin holder for a size L commercial embroidery machine bobbin.   It holds about a dozen pre-wound bobbins. 

I printed the teal colored one in PETG and the files posted are for a PLA version.  Either would be fine.  Support material is required.  I did not need a brim but it may not be a bad idea to add one if adhesion becomes an issue.

I adhere coin magnets to the back surface using epoxy but I figure super glue, CA glue, or hot glue would also probably work.  Then I can set the bobbin holder up on a nearby piece of metal.   Note:  Melco's have a lot of cast aluminum parts and magnets will not stick.  It will need to be something like steel for it to stick too.  This could be a cabinet, a shelf, a metal plate zip tied to something, etc.