1 / 6
Tripod Feet Remix for Insta360 Selfie Stick
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tripod Feet for Insta360 Selfie Stick or Most Monopods with more space for a ¼ inch metal screw
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 65
- Wydruki
- 0
- Wyświetlenia
- 488
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (5)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (18)Powiązane
This is a tripod for e.g. the Insta360 invisible selfie stick or any other camera mount with a standard ¼ inch screw mount. It's a remix of @OurAngryBadger very good remix.
Required Parts
- 3× M3x16mm screws
- 3× M3 nut
- 1× ¼ inch screw, 16-18mm long
- or the 3D-printed screw of the original remix
Printing
- 0.6mm nozzle recommended, but 0.4mm, to 0.8mm should all be fine
- layer height: 0.2mm to 0.3mm (I used 0.3mm with great success)
- wall strength/perimeters: ≥4 with 0.6mm nozzle or ≥6 with 0.4mm nozzle
- 25%-30% infill, honeycomb pattern
- top layers: 5
- bottom layers: 5
Assembly
- screw in the ¼inch screw from below for just a few mm
- make a sling with the lanyard and hook the screw
- screw the ¼inch screw in tightly, while keeping the lanyard ad the cut-out. This way, the screw should become flush with the connector
- one by one, add the feet and affix them with M3 screw and nut.