cpap reducing valve
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
cpap parts fan sometimes simply blows too hard for ASA or ABS. This valve will help you reduce the flow.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 66
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
When you have a cpap fan for parts cooler, you will almost never run it at full speed. Likewise, the lowest speed it will start at, mine is 16%, might sometimes be too much for dificult filaments like ABS or ASA. I use Spectrum ASA 275 and found that even at 16% it cools too much and fails the print. Now with this valve I can regulate the flow even lower and reduce it by a very significant amount.
I printed mine in DD PLA at 6 perimeters and the infil does not even matter. I slowed it down a bit to give the small areas some time to recover before being extruded on again.
no supports needed and I printed them together upright. totally no cleaning needed, just fit it as it is on your 24V WS7040 fan outlet and you are good to go.