cpap reducing valve
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
cpap parts fan sometimes simply blows too hard for ASA or ABS. This valve will help you reduce the flow.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 8
- Makes
- 0
- Views
- 66
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
When you have a cpap fan for parts cooler, you will almost never run it at full speed. Likewise, the lowest speed it will start at, mine is 16%, might sometimes be too much for dificult filaments like ABS or ASA. I use Spectrum ASA 275 and found that even at 16% it cools too much and fails the print. Now with this valve I can regulate the flow even lower and reduce it by a very significant amount.
I printed mine in DD PLA at 6 perimeters and the infil does not even matter. I slowed it down a bit to give the small areas some time to recover before being extruded on again.
no supports needed and I printed them together upright. totally no cleaning needed, just fit it as it is on your 24V WS7040 fan outlet and you are good to go.