DeWalt Magnetic Bit and Fastener Holder (ToolConnect versions)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Larger remix of a magnetic bit and fastener holder for DeWalt tools with the ToolConnect bump
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 202
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Liked the idea of a magnetic holder for screws, nuts, bolts, and bits, but the initial models I printed were both too small and did not fit well with the contours on the side of my DeWalt DCF845 driver (ToolConnect model). So remixed this Dewalt magnetic bits/screws holder by Alexandre M. by increasing the overall size, offsetting the mounting point slightly, and removing one of the “bumps” on the back of the model so that it would fit nicely with my tool. So much room for activities!
Should fit up to 6 total 12x3mm magnets, I ended up gluing smaller 3 mm thick magnets as that was what I had on hand. Right and left versions for using on the right or left (pictured) sides of the driver.