1 / 5
Snap Together Case Arduino Uno + Adafruit 1/2 perma proto board — zdjęcie 1
1 / 5

Snap Together Case Arduino Uno + Adafruit 1/2 perma proto board

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I didn't happen to have a prototyping shield board so I put together my project on a perma proto board I had lying…

Ocena
0 / 5
Polubienia
1
Pobrania
29
Wydruki
0
Wyświetlenia
346
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

I didn't happen to have a prototyping shield board so I put together my project on a perma proto board I had lying around and made this case. Everything snaps together. Optional button lines up with a pushbutton mounted on the proto board.

The pins the uno snaps into are pretty fragile due to their size... probably won't withstand removing and re-adding the board. Don't fear if the tops break off you can just drill a little hole in the remaining post and use a short screw.

Case has built in strain relief for cables included.

Category: Electronics

Tagi