Louvers for dryer vent cover (outside)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Louver flaps for an outdoor dryer vent cover.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 306
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
The louvers on my dryer vent cover needed to be replaced. I could not find replacements locally or online, so I made my own.
I'm not sure if they are a standard size, but they do fit the cover for houses in my neighborhood. The cover uses four louvers, so this model is a set of 4. I did it this way because I was not getting a good result when trying to print just one. Of all of the orientations I tried, standing them up and printing them as a group (with some small temporary pieces to hold them for stability) worked the best.
Build Notes:
- I highly recommend keeping the vertical orientation.
- Supports are required.
- Use PETG or other high-temperature filament.
- Infill and perimeter values will not matter.
- Layer height: 0.20
When the print is finished, carefully remove the support material and the 3 supporting struts along the back side (the louver tops).