Louvers for dryer vent cover (outside)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Louver flaps for an outdoor dryer vent cover.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 33
- Makes
- 0
- Views
- 304
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
The louvers on my dryer vent cover needed to be replaced. I could not find replacements locally or online, so I made my own.
I'm not sure if they are a standard size, but they do fit the cover for houses in my neighborhood. The cover uses four louvers, so this model is a set of 4. I did it this way because I was not getting a good result when trying to print just one. Of all of the orientations I tried, standing them up and printing them as a group (with some small temporary pieces to hold them for stability) worked the best.
Build Notes:
- I highly recommend keeping the vertical orientation.
- Supports are required.
- Use PETG or other high-temperature filament.
- Infill and perimeter values will not matter.
- Layer height: 0.20
When the print is finished, carefully remove the support material and the 3 supporting struts along the back side (the louver tops).