Angled Shelf Mount for Panasonic Baby Monitor Camera (KXHBC-200)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Angled shelf mount for the Panasonic KXHBC-200 baby camera. Makes it easier to see into the crib.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 50
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My friend bought the Panasonic KXHBC-200 baby monitor camera to keep a close eye on his new noisy and generally demanding obligation. He found that while it was a good camera, but was not able to tilt down far enough to fully see into the crib from the shelf positioned up above. 3D printing to the rescue!
The lower recess on the model holds onto a 90mm*15mm shelf he got from Amazon.
The camera is held in place on the angle by the center pin which extends into the camera itself, as well as an adjustable shim which slides into the groove of the camera and screws down. You only need one of the shims, three versions are available with slightly different radiuses in case there are different camera variants.
The camera can still rotate normally while in this mount, just be careful when placing the shim that it holds down the bottom half and doesn't apply friction to the top half.
No idea if this will help anyone else or not, but I hope it does. Figured the project shouldn't die alone on my SSD. Noncommercial license to help out the sleep-deprived parents out there.
Printing Advice
- Print the main body on its side and you shouldn't need supports.