1 / 6
Core One Holder arm for filament feeding from above, esp. for printing TPU
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Core One Holder arm for filament feeding from above, esp. for printing TPU
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 434
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (18)Powiązane
For printing TPU I used this Top Spool Holder https://www.printables.com/model/1160668-alternative-spool-holder-prusa-core-one but the TPU is not good inserted into the Nextruder.
For this I develop this pulley.
Needed parts:
- 1x Print part - Holder arm
- 2x Print part - Roll, support needed for the bottom hole for the ball bearing
- 1x M3*16 screw for the angle of the new arm
- 1x M5x20 screw or longer to screw the Holder arm into the “alternative-spool-holder”. a 4.8mm hole is needed inside this spool holder, can be done inside the Slicer before printing this good part.
- 2x M5x100 screw
- 2x M5 Lock nut
- 4x 695-2RS ball bearings for the “Roll” part, ID: 5mm, OD:13mm, 4mm thick, https://www.amazon.de/dp/B07TMBX23H?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
The normal Filament sensor should be switched off wenn using this mod, but this is clear, because I use NOT the PFTE with the sensor.