1 / 6
Core One Holder arm for filament feeding from above, esp. for printing TPU
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Core One Holder arm for filament feeding from above, esp. for printing TPU
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 21
- Makes
- 0
- Views
- 434
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
For printing TPU I used this Top Spool Holder https://www.printables.com/model/1160668-alternative-spool-holder-prusa-core-one but the TPU is not good inserted into the Nextruder.
For this I develop this pulley.
Needed parts:
- 1x Print part - Holder arm
- 2x Print part - Roll, support needed for the bottom hole for the ball bearing
- 1x M3*16 screw for the angle of the new arm
- 1x M5x20 screw or longer to screw the Holder arm into the “alternative-spool-holder”. a 4.8mm hole is needed inside this spool holder, can be done inside the Slicer before printing this good part.
- 2x M5x100 screw
- 2x M5 Lock nut
- 4x 695-2RS ball bearings for the “Roll” part, ID: 5mm, OD:13mm, 4mm thick, https://www.amazon.de/dp/B07TMBX23H?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
The normal Filament sensor should be switched off wenn using this mod, but this is clear, because I use NOT the PFTE with the sensor.