1 / 6
HGX-Lite Filament runout sensor — zdjęcie 1
1 / 6

HGX-Lite Filament runout sensor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

simple runout sensor utilizing a 8mm long 5mm diameter pin and a microswitch.

Ocena
5 / 5
Polubienia
42
Pobrania
198
Wydruki
2
Wyświetlenia
1005
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Runout sensor for the HGX-Lite

Measured in CAD theres about 23mm from trigger point to extruder gears not gripping anymore. so 20mm would be a safe “delay distance” or “extrude after runout” distance for this.


assembly:
- make sure the pin hole is clean
- insert the pin
- mount the microswitch
- screw in the fitting, add a spare piece of ptfe tube, insert filament to check fit
- lever the microswitch a bit until you hear the click disengage, then release some pressure till you hear it click back in.
- now fully screw in the adjustment screw to fix the microswitch in that exact position
- when happy with filament resistance and switch actuation, fully tighten the M2 that holds the switch.
- (looking at the front) insert the sensor in the (screw removed) hole with some pressure, tilt counter clockwise until it clicks in.
- screw in the 25mm M3 screw to finalize mounting.


required hardware:
- M3 x 25mm SHCS
- M2 x 8mm (or longer) SHCS (adjusting microswitch)
- M2 x 10mm SHCS (mounting microswitch)
- M5 x 8mm pin
- common microswitch
- PC4 M10 Pneumatic fitting (passthrough)
- (optional) M2.5 screw for extra mounting on the front.
 

Tagi