HGX-Lite Filament runout sensor
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
simple runout sensor utilizing a 8mm long 5mm diameter pin and a microswitch.
- Rating
- 5 / 5
- Likes
- 42
- Downloads
- 199
- Makes
- 2
- Views
- 1,012
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
Runout sensor for the HGX-Lite
Measured in CAD theres about 23mm from trigger point to extruder gears not gripping anymore. so 20mm would be a safe “delay distance” or “extrude after runout” distance for this.
assembly:
- make sure the pin hole is clean
- insert the pin
- mount the microswitch
- screw in the fitting, add a spare piece of ptfe tube, insert filament to check fit
- lever the microswitch a bit until you hear the click disengage, then release some pressure till you hear it click back in.
- now fully screw in the adjustment screw to fix the microswitch in that exact position
- when happy with filament resistance and switch actuation, fully tighten the M2 that holds the switch.
- (looking at the front) insert the sensor in the (screw removed) hole with some pressure, tilt counter clockwise until it clicks in.
- screw in the 25mm M3 screw to finalize mounting.
required hardware:
- M3 x 25mm SHCS
- M2 x 8mm (or longer) SHCS (adjusting microswitch)
- M2 x 10mm SHCS (mounting microswitch)
- M5 x 8mm pin
- common microswitch
- PC4 M10 Pneumatic fitting (passthrough)
- (optional) M2.5 screw for extra mounting on the front.