MXR M108S Back Plate / Base Plate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Created a base plate for the MXR 108S 10 band EQ pedal. This is for pedal board use that has Velcro for attachment.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 105
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Public Domain
Recommended settings…
- Print with the flat side down, use supports in the flat screw areas (the corner screws), it's not necessary to use support on the inner screws.
- 3-5 outlines/perimeters
- 5 top + 5 bottom solid layers
- 20-30% infill (I don't think it uses much due to thickness, you could probably do all solid layers)
- I did in this in FlashForge PLA, could prob do PETG too. Use whatever you like.
____________________________________________________________________________________________
Created a base plate for a Dunlop MXR M108S 10 Band EQ. No one seems to have created one so I made it in Rhino 3d. It is a tiny bit thicker than the original metal base plate, but this was necessary because it seemed to flex a bit when screwed in. All the screws are countersunk a lot better than the original metal plate as well with the added bottom thickness. I sanded the bottom of mine (you can see in the main image), hoping the Velcro will stick well when I put it on.
It probably doesn't matter much, but I recommend screwing the corners in with an X pattern one at a time, and to alternate between the 2 central screws. I felt that the screws were a tiny bit tight going in (probably from the super minute differences in hole placements). This is actually my 2nd version of the base plate and it is immensely improved. I measured the centers of all the holes with digital calipers this time, and the fit seems spot on.