1 / 2
Nikon F3 F3HP F3T Motor Drive Cap Cover MD-4 Threaded — zdjęcie 1
1 / 2

Nikon F3 F3HP F3T Motor Drive Cap Cover MD-4 Threaded

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A threaded motor drive cap for Nikon F3 bodies.

Ocena
0 / 5
Polubienia
5
Pobrania
91
Wydruki
0
Wyświetlenia
216
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Share Alike

A replacement motor drive cap for the Nikon F3 series of cameras. 

Printing recommendations:

  • Use the lowest layer height possible so the threads are properly formed. I used a 0.12mm layer height.

  • Print with a dark material that does not let light through. You can test this by holding the cap up to a light source.

  • Depending on your local weather or use case, consider printing with ASA or a material with a higher glass transition temperature than PLA. I have not experienced any warping, but I could see it happening in certain situations.


Installation:

  • Ensure the cover is placed flat against the camera body to prevent cross-threading. The cap should screw in fairly easily. 

  • Use a coin or screwdriver to gently tighten the cover. 


For the curious, the thread is M18x0.5.

Tagi