Nikon F3 F3HP F3T Motor Drive Cap Cover MD-4 Threaded
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A threaded motor drive cap for Nikon F3 bodies.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 91
- Makes
- 0
- Views
- 216
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Share Alike
A replacement motor drive cap for the Nikon F3 series of cameras.
Printing recommendations:
Use the lowest layer height possible so the threads are properly formed. I used a 0.12mm layer height.
Print with a dark material that does not let light through. You can test this by holding the cap up to a light source.
Depending on your local weather or use case, consider printing with ASA or a material with a higher glass transition temperature than PLA. I have not experienced any warping, but I could see it happening in certain situations.
Installation:
Ensure the cover is placed flat against the camera body to prevent cross-threading. The cap should screw in fairly easily.
Use a coin or screwdriver to gently tighten the cover.
For the curious, the thread is M18x0.5.
