Sunlu S1 Filanet dryer fan mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mounting part that allows for adding a 50mm fan into the Sunlu S1 Filament dryer.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 116
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
Custom fan mount made for the S1 filament dryer, for attaching a 50mm fan. Connecting the fan requires modifying the electronics of the dry box (perform at your own risk only if you know what you're doing) I soldered a voltage regulator to the power supply of the built in 24V heater (you can also solder it directly to the power supply, but the fan will be turned on whenever the filament dryer is plugged in), then soldered a female connector matching the fan, voltage regulator, set to output 11.8V. Fan is attached to the mount with four m3 screws. The enclosure has a slot for one M3 nut, which in combination with an M3 bolt, and a pre-drilled 3.5mm hole in the enclosure makes it possible to attach the assembly to the top of the enclosure.
Print out of a material that's more temperature resistant than PLA (Mine is made of Bambu Translucent PETG)
Fan:
https://botland.store/withdrawn-products/9440-fan-12v-50x50x10mm-with-3wires-5900804040699.html
Step down voltage regulator (to step the 24V power supply from the filament dryer, down to 12V the fan operates on):
(Not affiliated links)
Original CAD file made in onshape
Modeled based on this S1 3D model, inspired by another variation of a fan mount.