Scraper with 60 mm trapezoid blade
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The scraper handle for 60mm trapeziod blade with four holes.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 193
- Wydruki
- 2
- Wyświetlenia
- 1045
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The original handle of my scraper was not holding the blade, while I was removing a sticker, so I created more secure handle.
The blade can be easily pressed into the handle and sits firmly without play. From above the blade is secured by holder - M3 screw and nut are required to connect both parts. The cover snap in and secures the blade, when not used.
Approximate dimensions of the blade:
- length: 60 mmm,
- width: 18.7 mm,
- thickness: 0.65 mm.
Required for assembly:
- 1 x imbus screw M3 x 6 mm,
- 1 x hexagon nut M3.
Print settings:
- Layer height: 0.2 mm,
- Perimeters: 3,
- Solid layers - top/bottom: 5 / 5,
- Supports: No *).
There is additional file "bladeinterface" - it enables quick check if the blade will fit into the handle.
I printed my handle with PLA, but PETG should work too - for first checks of blade interface dimensions I used already PETG and result was fitting well.
*) Actually in final version of blade holder I used support in screw hole, to get better surface.