1 / 5
Arri Anti-twist Drill guide for mafer/super clamp
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Drill guide to add arri style anti-twist holes to a mafer/super clamp
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 266
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (21)Powiązane
A simple drill guide to add 3mm Arri style anti-twist holes to a standard mafer/super clamp.
Instructions:
- Attach the guide to the clamp with m5 screws. (10-32 screws required for Matthews clamps )
- Drill the 4x 3mm holes to about 4-5mm deep using a3mm bit.
- Remove the guide, clear debris from the holes
The other version “Mafer anti-twist drill guide v2”
Tools needed
Drill
No. 7 drill bit and 1/4-20 tapper tap
1/4-20 bottom tap
3mm drill bit
Tap handle
Instructions:
- Ideally secure the clamp in a vise or just clamp it to secure surface.
- Align the guide on the clamp
- Drill out the center hole with the no. 7 drill bit. You want to go a bit over 1/4in deep. You can measure first and put a tab of tape to act as a depth marker.
- Clear the chips and drill out the 4x 3mm holes. These need to be about 4 mm deep.
- Using the tappered 1/4-20 tap first (it's easier to align and keep perpendicular to the surface) Tap the 1/4-20 threads until it bottoms out.
- Remove the tap and clear the chips.
- Repeat with the bottom tap so the threads will be deeper.
- Clear the chips and you're done.