1 / 5
Arri Anti-twist Drill guide for mafer/super clamp
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Drill guide to add arri style anti-twist holes to a mafer/super clamp
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 55
- Makes
- 0
- Views
- 268
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial
A simple drill guide to add 3mm Arri style anti-twist holes to a standard mafer/super clamp.
Instructions:
- Attach the guide to the clamp with m5 screws. (10-32 screws required for Matthews clamps )
- Drill the 4x 3mm holes to about 4-5mm deep using a3mm bit.
- Remove the guide, clear debris from the holes
The other version “Mafer anti-twist drill guide v2”
Tools needed
Drill
No. 7 drill bit and 1/4-20 tapper tap
1/4-20 bottom tap
3mm drill bit
Tap handle
Instructions:
- Ideally secure the clamp in a vise or just clamp it to secure surface.
- Align the guide on the clamp
- Drill out the center hole with the no. 7 drill bit. You want to go a bit over 1/4in deep. You can measure first and put a tab of tape to act as a depth marker.
- Clear the chips and drill out the 4x 3mm holes. These need to be about 4 mm deep.
- Using the tappered 1/4-20 tap first (it's easier to align and keep perpendicular to the surface) Tap the 1/4-20 threads until it bottoms out.
- Remove the tap and clear the chips.
- Repeat with the bottom tap so the threads will be deeper.
- Clear the chips and you're done.