1 / 4
Fluval Spec 5 Aquarium Glass Lid Rails Mod — zdjęcie 1
1 / 4

Fluval Spec 5 Aquarium Glass Lid Rails Mod

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Alternate lid option for the Fluval Spec 5 Aquarium

Ocena
5 / 5
Polubienia
20
Pobrania
91
Wydruki
0
Wyświetlenia
1397
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Pets
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The plastic lid that comes with the Fluval Spec 5 Aquarium is extremely lacking. It doesn't have anything keeping it in place and has a long, open slit down the length of it that your fish can either jump out of, or your cat get in to.

I designed and printed these rails you can attach to both sides, and have a pane of glass or plexiglass cut at your local hardware store to fit. Use aquarium safe marine glue to attach them to the inside of the tank (pictured). I had the 3/32" (2.4mm) thick glass pane cut to 19 5/16" x 7". The 7" depth leaves about 1/4" overhang, so adjust down if you don't want that. If you leave a little overhang it gives you something to grab on to to slide it open/close. 1/8" or 3.2mm thick glass MIGHT fit as there is some wiggle room with 3/32", but I won't give any guarantees as I didn't try it. The height the rails rest at also leaves a very small gap between the glass lid and the tank glass, just enough for a little airflow but not enough for snails and the like to get out.

Print Settings

Printer Brand:

Dremel Digilab

Printer:

3D20

Rafts:

No

Supports:

Yes

Resolution:

.2mm

Infill:

30%

Filament: Unknown PLA Black

Category: Pets

Tagi