Large Layer Testing Cones
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A print to test printing large layers to see if filament will fully stick or not.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 39
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Public Domain
With the Bambu P1S and a 8mm nozzle and 0.48 or 0.56 layer heights I kept on having issues with filament not sticking to itself while printing so I created this model to test out what would fix it.
You print this model like a pyramid.
You can also cut it so that it's not as tall but this is a pretty small height.
Unfortunately, the only solution I found so far is Scarf joint seam plus Scarf around entire wall with Scarf joint for inner walls also enabled but this can increase print times by up to 25% depending on the model.
For now I've stuck to 0.4mm layer heights which doesn't exhibit this issue.