Sunlu S2 Dryer Silica Gel Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remixed Silica Gel Box for the Sunlu S2 Dryer, to assist with the filament drying process
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 97
- Wydruki
- 0
- Wyświetlenia
- 726
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
This Silica Gel Box is designed to stay inside the Sunlu S2 Dryer to keep the humidity down when drying and/or storing filament. Note that it is not meant as a dryer for Silica Gel, there are many other designs for doing this.
I remixed this rather good design to make it considerably larger, plus adding an internal lip to assist in keeping the Gel beads inside.
Printing
This needs a higher temperature material than PLA (btw. PLA-CF is also not temperature resistant). I tried ASA which I expect to work well, plus PETG which is more eperimental to see if it keeps its shape. I made a slight adjustment to the 'feet' to allow for the shrinkage I got with ASA.
UPDATE on using PETG: Don't. Just, Don't. Well, if you're curious to find out how long it takes to safely remove 3.4 Bajillion individual silicon gel beads from a Sunlu S2, I suppose you could - otherwise, Don't.
Printed with 3/3/3 walls/top/bottom and a 15% infill - the PETG was at 0.2mm height with a 0.4mm nozzle whilst the ASA was 0.24mm height with a 0.6mm nozzle - neither of which should matter much (just what I have installed on each printer I used).
The Base will need a little bit of support around the ‘feet’ - I expect either Normal or Tree would suffice so long as you select On Build Plate Only.
In Use
I expect that one won't need to replace the Gel for a while, just run the dryer at a high temp overnight to recharge the beads when needed.
If you like this model, then please:
EdinBearDragon