Ratrig V-Minion BTT 12864 Display Case w/Logo
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
12864 display case with Ratrig rat logo embedded. See the original design for the back of case and mounting bracket.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This may not be for many, but I never use the encoder (the knob), so this remix removes the hole and puts a logo in its place. Cutout for the reset button is still there. WARNING - you need to permanently defile your screen PCB by removing the knob. And it is on the difficult side to remove, you'll need an iron that puts out good power.
The STEP file has the main front case and embedded into it are two pieces which are the Ratrig logo, so three parts total which should make it easy if you have a MMU.
You'll need to do a filament change or have a MMU to print this. I don't have multicolor capability, so I did the following sequence:
- Start print with primary/accent color - Red in my case
- Pause before beginning part 2 or 3 (Rat logo pieces)
- Insert rat color - black in my case
- Resume print, which will color the rat.
- Pause after parts 2 and 3 are done (we are still on layer 1)
- Insert primary/accent color again
- Continue remainder of print
It might be safer to do two layers of the rat color, but I can't be bothered.
My print was done with:
- Ambrosia Matte ABS, Voron Red
- Fusion Filaments ABS 1.5 Carbon Rod Black w/sparkles
- 0.4mm nozzle
- 0.2mm layer height, although I think higher would be fine