1 / 3
Stronger UHP arms - V-Minion - Screw-on endcaps — zdjęcie 1
1 / 3

Stronger UHP arms - V-Minion - Screw-on endcaps

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Arm to hold a UHP-350 which is the original model, added two heatset locations so the end caps can be bolted on.

Ocena
0 / 5
Polubienia
3
Pobrania
13
Wydruki
0
Wyświetlenia
92
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I thought the following design was decent because you can use bolts to attach the cover(s) - I am only using the front cover but you can mirror this model to use front and rear.

https://www.printables.com/model/298752-uhp-350-power-supply-for-ratring-v-minion-slim-sup

To be clear - this remix combines two different models to be used together.

So by modifying these arms for heatsets, I used that front DC cover myself. There was minimal space for the heatset so it's pretty tight and the heatset might deform the bracket a little. I used a smaller than Voron-standard diameter heatset but sized the hole for kinda an in-between diameter. Alignment is also not perfect, but works well enough to hold a cover on.

BoM

  • M3 heatset
    • Can be the large diameter Voron-standard but this is probably least-desireable
    • 4.6mm diameter is better, depth not important, I made the hole deep
  • 50mm M3 bolt, anything shorter won't reach

Tagi