1 / 2
Creality K1/K1C Back Fan Cover with Fins — zdjęcie 1
1 / 2

Creality K1/K1C Back Fan Cover with Fins

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A Back Fan Cover made with ABS in mind, but with fins that open.

Ocena
4 / 5
Polubienia
27
Pobrania
151
Wydruki
2
Wyświetlenia
541
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

About

This remix was created from the need to have higher chamber temperatures, but still have control over it.

The fins are made very light so that the fan turning on opens it. It is not perfect yet, it could have a better seal, but it works as intended.

I recommend ABS or higher, but PETG might hold as well.

Assembly

Assembly is made with a piece of filament.

  1. Run the filament through the hole on the cover.

  2. Run it through the fin slot.

  3. Position the fin.

  4. Run through the other side.

  5. Cut the ends.

  6. Repeat.

I believe the fins will work both ways, but the intended way is with the filament opening facing the outside.

Tagi