Single-Left-Hand Joy-Con Adapter (+ Status Light, Wristband and Tactile Marking)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapted single-right-hand switch joy-con adapter with holes for status lights, a wristband and additional tactile marks
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 115
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Single-Left-Hand Joy-Con Adapter (+ Status Light, Wristband and Tactile Marking)
This is an adaptation to the design of Single hand Joy-Con adapter (Left) by Vexelius, so, thanks for this!
For a group project at university, we adapted the controller adapter concerning some remarks, that were mentioned by commenters previously. This includes adding holes for the status lights, as well as adding a hole for a wrist-band (e.g. using a ribbon) and some tactile information (+/-) about which controller goes where, which will hopefully improve this design even further.
Though we ourselves are not one-handed, and can therefore only give limited feedback, we still tried to test the design playing e.g. Mario Kart. As far as we could tell, this tool definitely makes playing the switch possible only using the left hand. It takes some time to get used to it, but so far, we were able to use it quite seamlessly. It is especially helpful that the orientation of the direction joystick is still mapped to left being left and right being right. We also tested that we could slide the joycons into the adapter with one hand only.
We hope that this version might be helpful for some peers which temporarily or permanently can only use their left hand for gaming. It would also be super awesome, if places where people often play together, also printed some of those as well, just in case that some people might need them.
As this is only a 3D-file and the question arose sometimes before, you sadly cannot order this, and we are also not capable to print and ship this. But if you live in Australia, you can go check out Access3D, which will probably print this for you with you only needing to pay for the shipping. You can also have a look at a MakerLab nearby and ask them for some help. On the other hand, if you have the capability to print for others, and this is your hobby, I can highly recommend MakersMakingChange, as they always have open requests, which you could use your printer for.
Have fun playing!
Print information:
We tested with different 3D printers, e.g. Bambu X1. We used black PLA, a brim and printed it upright. The resolution was 0.08mm. We adapted the design using Fusion 360.