1 / 1
Dranjer F-Series Dehumidifer Inlet Cover — zdjęcie 1

Dranjer F-Series Dehumidifer Inlet Cover

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a dehumidifer hose inlet cover for a Dranjer F-Series Sump Pump Inlet.

Ocena
0 / 5
Polubienia
1
Pobrania
5
Wydruki
0
Wyświetlenia
33
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This is a drop in replacement inlet cover for a Dranjer F-Series Sump Pump Inlet. It's designed to both allow water into the sump pump through the smaller inlet holes while also supporting a 15-18mm dehumidifer inlet hose in the middle.

This screws into the existing Dranjer F-Series. The hose inlet in the middle was specifically sized for a Midea Cube 35

This model uses 9.56 grams of filament, and takes 29 minutes to print on a P1S using the print profile outlined below. You can use less infill and wall loops if necessary, but you won't reduce the filament usage significantly. It can save you ~15 minutes of print time, however.

The inlet cover can be printed in PETG, ASA, or other moisture resistant filaments. I have printed this successfully in both PETG-HF and ASA, and will update how well they hold up with constant use.

Printing Guidelines

Materials: PC, ASA, or PETG-HF.

Infill: 40% Gyroid

Walls/Wall Loops: 5

 

Tagi