Typewheel 440 and 497 Italic for Blickensderfer typewriters
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Typewheel 440 scientific and 497 universal English Italic
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 128
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Italic English layout typewheels for the Blickensderfer typewriter. For scientific keyboard number 440 or universal keyboard layout wheel number 497.
Recommended to print on an FDM printer with
- a small nozzle; ideally 0.2 mm
- small layerheight of not more than 0.1, ideally less
- PLA (black) material for good surface and strong resilient wheel
After printing, apply a tiny drop of cyanoacrylate (superglue) to the stub on top of the wheel and give time to fully set.
Use a fine, round file to remove or smoothen any printing-imperfections of the inside mounting hole.
Bend a retaining clip from 0.5 mm steel wire (or use a small safety-pin).
Check for free-fitting on the shaft of the typewriter; the wheel should rotate freely on the shaft, but should have no play.