NanoBeam AC5 2Gen Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The NanoBeam comes with a pole mount only, the wall mount is an option. This is a replacement for the later.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 184
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a remix of the original nanobeam mount by @Harry, this version adds a recess to the back of the mount to fit an M6 bolt in for a stronger hold with metal M6 screws. This was probably overkill but I felt safer mounting it with a metal nut.
Original Makers Notes:
Thank you for supporting me!
This is another free 3D model made available for you. I love sharing my models, but designing, testing, polishing, uploading and maintaining them is a lot of work. In case you enjoy this model, please leave a small Donation or Buy me a Coffee. Thank you!
Printing
All parts can be printed without support. For the mounts, place wall side to build plate.
There are two options for the screw:
- Use a metal M6 screw with thread length 60mm. Take care to not tighten the screw too much - the mount will break at a certain point.
- Use Screw.stl. When printing the screw, print it horizontal - it will break quickly otherwise. In addition, I recommend drilling the printed screw into a metal M6 nut before using it. This will hone the thread so it does not damage the mount thread.
25% infill makes sense for windy conditions. Select the mount stl matching the wall angle required. The photo attached shows the 45 degree version in foreground.