Tiny T114 Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a tiny Heltec T114 mesh node, intended for Meshtastic.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 476
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
This is a minimal case for the Heltec T114, intended to use the stock “black spring” IPEX antenna:
https://heltec.org/project/mesh-node-t114/
It is intended to fit a vibrate motor and a 10mm speaker - however I was deeply un-impressed with the little speaker so I removed the sound hole. I am happy to release a version with the hole!
I suppose you could just put two vibrate motors in….
Battery:
Vibrate Motor:
For wiring the vibrate motor, I highly recommend using the GPS connector's controlled 3.3V output (GND and Ve_3V3), which is controlled by GPIO21:
I removed the GPS connector and directly soldered to the pins - but if you're not comfortable doing that, I would get a pre-crimped connector kit and make your own plug:
Have fun! If this case gets popular I am happy to entertain suggestions/improvements.