Plunger tube for Ontos
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Referenced SillyButts Plunger tube design to create a variant for the Ontos.
- Ocena
- 5 / 5
- Polubienia
- 52
- Pobrania
- 148
- Wydruki
- 3
- Wyświetlenia
- 1134
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Referenced SillyButts Plunger tube design to create a variant for the Ontos. 150mm long and OD of 35mm ID (with the plastic insert) is 32mm. Works great!
I have tested it and barely noticed a drop in FPS compared to the aluminum tube.
I would print the tube at a .28 layer height for strength and speed of print -but you don't have to.
For the insert, make sure its .20 layer height, so it ends up being .40mm thick. Also print on a SMOOTH plate, as this is what the rubber o-ring will be riding on. Smooth is key!
To assemble, Roll up the insert with the smooth side facing in, insert it in the tube. Lube up with a bunch of lube.
I have included the step file. This is my first time designing something like this, so let me know if i can make any changes! Also report back to let me know if you are using it and it works for you too.