1 / 3
Lian-Li Lancool 207 Dust Protection and Airflow Optimization — zdjęcie 1
1 / 3

Lian-Li Lancool 207 Dust Protection and Airflow Optimization

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A press-fit plate to block dust entry from the rear of the case and mitigate warm air short-cycling.

Ocena
0 / 5
Polubienia
11
Pobrania
85
Wydruki
1
Wyświetlenia
621
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I recently built a new PC and was impressed by the aesthetics and performance of the Lian-Li Lancool 207 case. However, I found a design flaw at the rear of the case. The large hexagonal mesh has two issues:

  1. The bottom fans can suck in large dust particles. This is a particular issue for users (like me) who have the case on the ground.
  2. The opening is right next to where the warm air exhausts. In theory, this presents an opportunity for warm air to re-enter the case. 

My solution is a simple press-fit plate that covers the hexagonal mesh at this section:

  1. While not a hermetic seal, I have not found any more dust bunnies in my GPU. 
  2. Completely walling off this section hasn't perceptibly changed thermal performance; however, I have some peace of mind knowing that design best practices are now implemented. 

I have included the .STEP file should you need to tune the peg sizes for your printer.