Makita Makpac 3 drillbit case holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Makita Makpac 3 x75 pcs drillbit case holder
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 455
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
The x75 drillbit case that came with my Makita DHP485 LXP drill only fits inside the Makpac one way, ("flat"), and I wanted to fit as many of my tools as I can into it.
This holder works with the “Makpac 3” version of the Makita case which is around 395x295x210mm big. I'm unsure if it would fit bigger/smaller cases, however if you bought one of these drill sets, I believe should have a Makpac 3. Double check! Otherwise, step files are included.
These cases can vary in dimensions slightly due to how they are manufactured because they are injection molded, meaning, inner surfaces like the ones I used for the mounting are usually slightly angled rather than straight, your mileage may vary during installation. I personally had to use the rubberized end of my plumber's wrench to fit the left part in, the right one fit in with some force by hand. Holds tight. Add glue if you want or double sided tape if it's loose for you, or, again, step files are included.
Just print with a 0.20 “strength” profile and it should be rock solid.