1 / 5
Hand Fan - Naruto Theme (Sasuke's Eternal Mangekyou Sharingan) — zdjęcie 1
1 / 5

Hand Fan - Naruto Theme (Sasuke's Eternal Mangekyou Sharingan)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a fun print of a hand fan for the upcoming summer days. The fan has Sasuke's Eternal Mangekyou Sharingan design

Ocena
0 / 5
Polubienia
5
Pobrania
9
Wydruki
1
Wyświetlenia
142
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Hello Everyone, 

This is a custom fan design that incorporates Sasuke's Eternal Mangekyou Sharingan design.

The fan is 8.0" in diameter plus another 1.0" for the handle. 

This is fan is a fun print for the summer but can also double up as a decor item for your anime collection. There is a .196" hole so you can hang on the wall. 

I was able to print this using the MK4S with MMU3. I used the following filaments. 

  1. Elegoo PLA in Black
  2. Eryone PLA in Galaxy Red

You will need to print the following:

2pcs of Mangekyou_Sharingan_Fan_Panel_Design

1pc of Mangekyou_Sharingan_Fan_Frame

Printing and Assembly Instructions: All parts were printed in .250mm Speed Presets, only changed infill pattern to Gyroid, and no supports (both MK4S and CoreOne can print steep overhangs, verify your machines capabilities, enable supports if needed).

  1. Print the two panels first (if wanting texture on both faces of fan) or increase the thickness of a single panel to .050" (with increased diameter, quantity of panel is 1)
  2. Slice the Frame and add a pause to be able to insert the panel(s) into the frame. Depending on the layer height ensure you set the pause right before the top masking of the frame is printed as this will be directly on the panel after it has been inserted. 

Below is an example of where the print should pause to place the panel. Ensure your panel placement is correct. If printing with texture, ensure textured faces are facing outwards from both sides.

3. Resume print and allow to finish.

4. Enjoy your new 3d print!

Tagi