1 / 4
Nikon F3 MD-4 Motor Drive Terminal Cap Covers
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement terminal cap covers for the Nikon F3 MD-4 motor drive attachment.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 77
- Wydruki
- 0
- Wyświetlenia
- 233
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
Replacement caps/covers for the Nikon F3 MD-4 motor drive attachment.
Printing Recommendations:
- Use the lowest layer height possible so the threads are properly formed. I used a 0.12mm layer height.
- 100% infill
- Depending on your local weather or use case, consider printing with ASA or a material with a higher glass transition temperature than PLA. I have not experienced any warping but I could see it happening in certain situations.
The external power terminal (smallest cap) is identical to the Nikon F3 flash sync terminal.
For the curious, the thread sizes are:
- External Power Terminal: M7 x 0.5
- Remote Terminal: M9 x 0.5
- Magazine Back Terminal: M11 x 0.5
